Perabuild

Product Code: MXRP-2 Features: High Flexibility, Good adhesion, Quick sandable. FLEX FILL 2 is a highly flexible compound for use as crack filler for interior and exterior masonry and metal surfaces. PROPERTIES DATA UNITS Resin Type Acrylic - Drying Times - Touch Dry Depends on thickness minutes Drying Times - Hard Dry Depends on thickness hours Over coating Time 2 Depends on thickness hours Recommended number of coats N/A - Coverage N/A m²/Ltr Surface Appearance Smooth - Cleaning Solvent Water - Shelf Life 6 Months month Available Colours White - Unit sizes and weights 5Ltr = 5.5kg, 1Ltr = 1.1kg Ltr = kg NB: FLEX FILL 2 may be used to repair cracks in swimming pools or any other area where it will be covered by water. Tools must be cleaned with water immediately after use. For application surfaces, other than above, please contact our sales department Cracks and small holes in plaster Surface must be clean and dry. Remove any crumbling plaster. Apply FLEX FILL 2 into cracks with a skimming blade. Leave to dry and sand smooth. If necessary apply again. WOOD, METAL ...

Product Code: MXF-2 Features: Univeral Filler for interior and exterior use. POWDER FILL dries to a solid and tough product that can be sanded easily to a smooth surface. This filler does not absorb water or humidity. POWDER FILL is suitable for filling small cracks, holes and other defects. It is also possible to skim uneven surfaces to a smooth finish with POWDER FILL. PROPERTIES DATA UNITS Resin Type Combination of Mineral Compounds - Drying Times - Touch Dry Depends on thickness minutes Drying Times - Hard Dry Depends on thickness hours Over coating Time 1 Depending on thickness hours Surface Apperance Matt White - Cleaning Solvent Water - Shelf Life 6 Months month Available Colours White - Unit Size and Weights 20kg, 10kg, 5kg, 2kg, 500g bag Mix POWDER FILL with water to a lump-free stiff paste. Apply this paste with a skimming blade or scraper within 15-20 minutes after mixing. After drying (hardening) sand to a smooth surface and remove the dust. Apply SEALER (MB-30) over prepared POWDER FILL. PLASTER Plaster must be dry and solid. Apply POWDER FILL. After drying of filler, sand to smooth surface. Apply SEALER (MB-30) over filler. PRIMED PLASTER It is preferred to fill up holes and blemishes once the walls are primed. This gives better visibility. POWDER FILL can be applied on PVA based wall-primers, but must be sealed with SEALER (MB-30). EXISTING PAINTED SURFACES POWDER FILL can be applied on existing PVA paint coating. For use on eggshell or high gloss enamels sand substrate well to a matt surface. Apply POWDER FILL. After drying of filler, sand to smooth surface. Apply SEALER (MB-30) over filler. WOOD, FIBREBOARD OR SOFTBOARD FLEX FILL (MXRP) is recommended for this application.  Gloves X Mask X Goggles - Swallowed Rinse mouth with water. Give water to drink. Seek medical attention! Eye Contact Rinse eyes with water and seek medical attention! Ventilation Ensure adequate ventilated application area. Spillages Prevent runn off into drains or water ways. Storage Keep container tightly closed. Store in cool, dry place out of direct sunlight Flammable Not flammable. Always keep product out of reach of children. Do not ingest. Avoid eye contact. ...